I have a question for the board again!!

I want to activate power attack and keep it at +5 but it seems to reset itself after 5 seconds or so. Is there any way I can keep it set at +5 (or greater) without having to go back and manually set it all the time.

By the way I have NWN Diamond Edition with a whole bunch of CEP and PRC haks added on. My character is 33rd level with the power attack feat btw.

Thanks

The default behavior for NWN is jut a flat +5 when using PA. There's no choice as to how much or how little you can set it, so this sounds like a change made via the PRC. So I'd check the documentation to see if it mentions anything about keeping it activated.

I've had the same issue for as far back as I can remember. For some reason, it "conventiently" deactivates itself when you move or something. It seems that if you just click on enemies to move about combat (instead of manual WASD running), it won't deactivate... I think. What a pain. :/ And I'll mention I'm not using PRC or anything special.

Power Attack is active in Combat Mode only.
Therefore you cannot keep it activate unless you are in a combat.
I would not say battlefield because it will deactivate where the enemies are out of reach. (Not sure is it apply to range weapons as they are weak and seldom use.)